How do I reset my Antminer s9j?

After powering on the miner for 2 minutes, please press “Reset” button for 5 seconds, then release it. The miner will be restored factory settings within 4 minutes and automatically restart (no need to power off the miner).

How do I reset my a1 miner?

Press and hold Reset button more than 3 seconds to restore the default settings of the miner.

What is Antminer username and password?

The default account is: username ‘root’, password ‘root’.

How do I reset my S17?

Restore with hard reset or Recovery mode HomTom S17

If you can not unlock the screen, press and hold the power button for about 20 seconds and the phone will turn off.

How do I change my IP on Antminer?

This applies to all Antminers.

How to set a static IP address

  1. After logging in to your miner’s User Interface, click the “Network” tab and choose “Static” from the “Protocol” drop down list.
  2. Then key in your IP address, subnet mask, SWG, DNS.
  3. Click “Save&Apply”, and there you have it!

How do I use IP Reporter Antminer?

Follow these steps:

  1. Extract the file to a convenient location on your computer.
  2. Right‐click IPReporter.exe and run it as Administrator. …
  3. Select either of the following options: …
  4. Click “Start”.
  5. On the miner control board, press and hold the IP Report button for five seconds, until it beeps.
INTERESTING:  What moves the price of an ETF?

How do I set up S9j?

How to set up a new S9i/S9j

  1. It is recommend to use a power supply offering 20% more than the miner’s power requirement.
  2. PoE is not supported.
  3. Only Ethernet network connection supported.
  4. Use the miner in an environment between 10 to 35 degree Celsius.
  5. Keep the miner’s surrounding humidity below 65%

How do you reset an Antminer l3 ++?

On the controller front panel, press and hold the Reset button for 10 seconds. Resetting your miner will reboot it and restore its default settings. The red LED will automatically flash once every 15 seconds if the reset is operated successfully.

How do I factory reset my Antminer s9?

After powering on the miner for 2 minutes, please press “Reset” button for 5 seconds, then release it. The miner will be restored factory settings within 4 minutes and automatically restart (no need to power off the miner).

How do you reset an Antminer d3?

On the controller front panel, press and hold the Reset button for 10 seconds. Resetting your miner will reboot it and restore its default settings. The red LED will automatically flash once every 15 seconds if the reset is operated successfully.